3025 - 1/2" EXTRUSION FEMALE for use with quick clamps (12 ft. Cut in Half)
- In Stock
- 4.19 LBS
- 1.19 (in)
- 144.00 (in)
- 1.19 (in)
- Calculated at Checkout
THIS ITEM SELLS IN 12 FT. STICKS & MUST SHIP CUT FOR GROUND SHIPPING. IF YOU REQUIRE THE STICKS UNCUT FOR YOUR PROJECT, ADDITIONAL SUBSTANTIAL COST WILL BE REQUIRED FOR FREIGHT SHIPPING
Fits Most Domestic Laminates.
USES QUICK CLAMP FW18
Heavy Duty Groove Extrusion mates with 3024 Tongue Extrusion.
Board thickness: 13.7mm / 9/16"
NOTE: Mill finish unanodized extrusions can commonly incur surface abrasions during shipment from rubbing together if they incur harsh handling during the shipment process. This is not abnormal, and is easy to remedy by rubbing the extrusions with some #0000 Fine Grade Steel Wool, cheaply available at any hardware store.
Rivets Required For Installation: Varies depending on length of section used, as well as associated parts that may be riveted through it.
Depending on your case design some rivets may require backing washers. Most rivets will install through the interior leg of the extrusion and therefore require no backing washers.
See Parts Pictures Above