QUICK LID™ SETUP

QUICK LID™ SETUP

quick-lid-logo-for-store.jpg

The components in this section (seen below all of this information) must be used together to create our Quick Lid™ Setup. This simple system is an exceptional alternative to the expense, weight, and bulkiness associated with traditional removable lids. While it is not applicable in all case scenarios, when feasible it is an excellent substitute for traditional removable lids. The system may be used for top, front & rear removable lid applications. How so you ask? Let's take a look at a few examples . . .


lid-comparison-for-store.jpg


NOTE: The Quick Lid™ Setup is designed for cases built with 3/8" thick case walls. However, may also be used with cases made with 1/2" walls by simply routing down the edges of the 1/2" case wall ends to fit the extrusion channels. You would also need to route the perimeter edges of the removable panel to allow it to sit flush within the extrusion.

BE SURE AND SEE THE PHOTOS WITHIN THE PRODUCT DETAILS SECTIONS FOR EACH PART LISTED BELOW, WHICH DETAIL EXACTLY HOW THIS SYSTEM AND ITS PARTS WORK. 

  • Quick Lid™ Latch
    Add to Cart

    Quick Lid™ Latch

    $11.50
    Quick Lid™ Latch - This special internal finger-operated latch is used as part of our Quick Lid™ System. This particular finger-operated latch installs on the inside of the Quick Lid™ Panel. A small finger access...
    $11.50
    Add to Cart
  • Quick Lid™ Latch / Locking
    Add to Cart

    Quick Lid™ Latch / Locking

    $11.95
    Quick Lid™ Latch - This special internal finger-operated latch is used as part of our Quick Lid™ System. This particular finger-operated latch installs on the inside of the Quick Lid™ Panel. A small finger access...
    $11.95
    Add to Cart
  • Quick Lid™ Extrusion  -  3/8" -  6.5 ft.
    Choose Options

    Quick Lid™ Extrusion - 3/8" - 6.5 ft.

    $19.50
    Quick Lid™ Extrusion - This custom extrusion is part of the Quick Lid™ System used to create removable lid panels instead of creating a full-blown lid. Available for 3/8" case walls only. If you want to use it with 1/2" case...
    $19.50
    Choose Options
  • Add to Cart

    Quick Lid™ Corner / Custom 2-Leg

    $1.15
    Quick Lid™ Corner. This special 2-leg corner is for use only with our CNSL0490 Quick Lid™ Extrusion. This special 2-leg design has channels that wrap the interior corners of the CNSL0490 Quick Lid™ Extrusion. Contact...
    $1.15
    Add to Cart
  • Quick Lid™ Corner / Standard 3-Leg
    Add to Cart

    Quick Lid™ Corner / Standard 3-Leg

    $1.00
    Quick Lid™ Standard 3-Leg Corner. This matching 3-leg version corner is used on the other four corners that are not part of removable panel scenario. See how the entire system works below.Rivets Required For Installation: 3Depending on your case...
    $1.00
    Add to Cart
  • Quick Lid™ Hook Plate
    Add to Cart

    Quick Lid™ Hook Plate

    $2.25
    Quick Lid™ Hook. This special hook installs on the inside bottom areas of the Quick Lid™ Panel and catches on our CNSL0490 Quick Lid™ Extrusion during panel insertion prior to pressing the  Quick Lid™ Latch into place to...
    $2.25
    Add to Cart