Corner Brace - Deluxe - Offset
- In Stock
- 0.08 LBS
- 2.02 (in)
- 1.85 (in)
- 2.02 (in)
- Calculated at Checkout
Heavy Duty Steel Corner Brace With Offset For Extrusions. Mates with all of our standard double angle corner & hybrid extrusions for 1/4", 3/8", and 1/2" wall panel thicknesses.. Provides for the most professional flush and clean fit with extrusions. Covers gaps and seams between the tongue & groove and corner extrusions while allowing the shape of the brace to sit flush against the case wall for that professionally crafted look.
Rivets Required For Installation: 6
Depending on your case design and dimensions, some rivets may require backing washers. Some rivets will install through the aluminum extrusions and therefore require no backing washers.
THIS ITEM REQUIRES NO CUTOUTS IN THE CASE WALL TO INSTALL.
MINIMUM RECOMMENDED CASE DIMENSIONS:
- All Cases
ASSOCIATED COMPATIBLE PARTS:
- All Of Our Extrusions
Finish: Zinc Finish (unless another option is listed)
Material: 1.2mm/ 0.047" Steel
See Parts Pictures Above
It hugs the extrusions tightly and doesn't require much chamfering to seat properly. Also makes the not-quite-perfect seams look clean.
High quality brace, looks good
Had a piece of extrusion that was slightly too short on once side. You can't even tell with these corner braces.
Nice finishing touch with offset. Would like to see made with heavier gauge material. Still a quality product.
Good quality material and fits perfectly.
These corners are perfect.