Flat Corner - Small
- In Stock
- 0.11 LBS
- 1.92 (in)
- 1.85 (in)
- 1.92 (in)
- Calculated at Checkout
Small Steel Flat Corner. Smaller profile. Covers the joint and seams between the extrusions at all corners.
Rivets Required For Installation: 3
Depending on your case design and dimensions, some rivets may require backing washers. Some rivets will install through the aluminum extrusions and therefore require no backing washers.
THIS ITEM REQUIRES NO CUTOUTS IN THE CASE WALL TO INSTALL.
MINIMUM RECOMMENDED CASE DIMENSIONS:
- All Cases
ASSOCIATED COMPATIBLE PARTS:
- All Of Our Extrusions
Finish: Zinc Finish (unless another option is listed)
Material: 1.0mm/ 0.039" Steel
See Parts Pictures Above
I apologize. There is a medium size so one would not need to be added.
These are very strong and work well to cover the trim piece seams and to protect the corner, but they are almost too small based on the width of the trip piece. They come about a 1/8 of an inch past the trim so it is just enough to cover it, but it is close. The large corner would be too big for some application because the length of the corner would exceed the length of the side. I would recommend that a medium size is added, but these work just fine.