Lidmaker #2 / Extrusion 1/4" - 6.5 ft. / With Catch Channel
- In Stock
- 2.24 LBS
- 1.77 (in)
- 78.00 (in)
- 1.18 (in)
- Calculated at Checkout
Lidmaker Extrusion. This extrusion is used for creating low profile (thin) lids for cases. It has a built-in hybrid tongue & groove that mates with our other stand-alone hybrids to create the lid closure. It also has a built-in channel that acts as the catch/keeper for the hook on our Valance-spanning Latches (see graphics below).
NOTE: Mill finish unanodized extrusions can commonly incur surface abrasions during shipment from rubbing together if they incur harsh handling during the shipment process. This is not abnormal, and is easy to remedy by rubbing the extrusions with some #0000 Fine Grade Steel Wool, cheaply available at any hardware store.
MATES WITH THE FOLLOWING PARTS ONLY:
- CNSE0850 or CNSE2507 Hybrid Tongue & Groove Extrusion (seen here & here)
- CNSL0737/54 Small Valance-Spanning Latch (seen here)
- CNSC1358Z Brace Ball Corner (PREFERRED) (seen here)
(or CNSC1082Z Brace Ball Corner if CNSC1358Z is out of stock) (seen here)
Material: Mill Finished Aluminum