Quick Lid™ Corner / Standard 3-Leg

(No reviews yet) Write a Review
SKU:
C0675Z
Availability:
In Stock
Weight:
0.11 LBS
Width:
1.92 (in)
Height:
1.85 (in)
Depth:
1.92 (in)
Shipping:
Calculated at Checkout
  • Quick Lid™ Corner / Standard 3-Leg
  • Quick Lid™ Corner / Standard 3-Leg
$1.00

Description

Quick Lid™ Standard 3-Leg Corner. This matching 3-leg version corner is used on the other four corners that are not part of removable panel scenario. See how the entire system works below.

4 each required per Slam Lid.

Rivets Required For Installation: 2

ASSOCIATED COMPATIBLE PARTS:
- CNSL0490 Quick Lid™ Extrusion
- CNSL2470 Quick Lid™ Latch
- CNSP2472 Quick Lid™ Hook Plate

Finish: Zinc Finish (unless another option is listed)

Material: 1.2mm/ 0.047" Steel

Rivets Required For Installation: 3


Depending on your case design and dimensions, some rivets may require backing washers. Some rivets will install through the aluminum extrusions and therefore require no backing washers.

 

HOW IT WORKS 


#1 - The front, back, or top panel of the case is an inset removable panel held in place by a custom extrusion, custom two-leg corners, specially designed hook plates, and a spring-loaded internal latch. Multiple latches may be used for larger panels.

slam001.jpg

  

#2 - Stick your finger into the access hole for the internal latch and push down on the internal spring-loaded latch mechanism to release the panel from the custom extrusion framework.

slam002.jpg

  

#3 - Pull the removable panel from the custom extrusion framework.

slam003.jpg

 

#4 - As you detach the removable panel, you can see the two hook plates with their offset flanges that grab the lip of the custom extrusion. Together with the internal spring-loaded latch(es) these hook plates act to firmly secure the panel to the extrusion framework. The latch can be installed with wood screws for a "clean" exterior look, or with rivets just as you would install any other part (and since this latch is internal, just make sure the rivet is installed so that the rivet head is on the EXTERIOR of the case!)

slam004.jpg

 

#5 - Here is a reverse view of the two hook plates and their offset flanges that grab the lip of the custom extrusion.

 slam005.jpg

View AllClose

Additional Information

Specifications Drawings:
See Parts Pictures Above
View AllClose

0 Reviews

View AllClose