E2367/2000 - 3/8" PANEL JOINER EXTRUSION - (79" length)
- In Stock
- 4.23 LBS
- 2.20 (in)
- 79.00 (in)
- 0.64 (in)
- Calculated at Checkout
Panel Extender Extrusion. Used to extend multiple panels for larger-sized cases utilizing 3/8" case walls. It is recommended that other internal bracing be used for structural, and strength, reinforcement as well.
NOTE: Mill finish unanodized extrusions can commonly incur surface abrasions during shipment from rubbing together if they incur harsh handling during the shipment process. This is not abnormal, and is easy to remedy by rubbing the extrusions with some #0000 Fine Grade Steel Wool, cheaply available at any hardware store.
Rivets Required For Installation: Varies depending on length of section used, as well as associated parts that may be riveted through it.
Depending on your case design some rivets may require backing washers. Most rivets will install through the interior leg of the extrusion and therefore require no backing washers.
Material: Mill Finished Aluminum
See Parts Pictures Above