Lid Maker 1/4 6.5 feet E2540
- 3.56 LBS
- Calculated at Checkout
45mm x 30mm / 1.77" x 1.18" Lid / Base Extrusion with Built-in Striker for Latches
Board thickness: 7mm / 1/4"
MATES WITH THE FOLLOWING PARTS ONLY:
Hybrid Tongue & Groove Extrusion CNSE2507
Small Valance-Spanning Latch CNSL0737/28
Lidmaker Extrusion. This extrusion is used for creating low profile (thin) lids for cases. It has a built-in hybrid tongue & groove that mates with our other stand-alone hybrids to create the lid closure. It also has a built-in channel that acts as the catch/keeper for the hook on our Valance-spanning Latches (see graphics below). NOTE: Mill finish unanodized extrusions can commonly incur surface abrasions during shipment from rubbing together if they incur harsh handling during the shipment process. This is not abnormal, and is easy to remedy by rubbing the extrusions with some #0000 Fine Grade Steel Wool, cheaply available at any hardware store.