B1930/01 - CORNER BRACE - large
- SOLD OUT - Due End of August
- 0.08 LBS
- 2.00 (in)
- 1.65 (in)
- 2.00 (in)
- Calculated at Checkout
Heavy Duty Ribbed Steel Corner Brace - Mates with all of our extrusions for 1/4", 3/8", and 1/2" wall panel thicknesses. Provides a clean fit with extrusions. Covers gaps and seams between the tongue & groove and corner extrusions.
Rivets Required For Installation: 4
Depending on your case design and dimensions, some rivets may require backing washers. Some rivets will install through the aluminum extrusions and therefore require no backing washers.
THIS ITEM REQUIRES NO CUTOUTS IN THE CASE WALL TO INSTALL.
MINIMUM RECOMMENDED CASE DIMENSIONS:
- All Cases
ASSOCIATED COMPATIBLE PARTS:
- All Of Our Extrusions
Finish: Zinc Finish (unless another option is listed)
Material: 1.2mm/ 0.047" Steel
See Parts Pictures Above
I ordered this item through DIY Road Cases' Canadian distributor Penn-Elcom. As I am building a vintage 1970's guitar case, I needed these specific corner braces. I scoured the Google but could only find them on DIY Road Cases / Penn - Elcom's website. The corner braces are of a high quality and fit perfectly for my application. The order and delivery process was completed perfectly. Many thanks to Dale for his expertise. I will most certainly use DIY Road Cases / Penn-Elcom in the future.