C0680Z - QUICK LID CORNER / custom 2 leg
- In Stock
- 0.13 LBS
- 2.09 (in)
- 1.80 (in)
- 2.09 (in)
- Calculated at Checkout
Quick Lid™ Corner. This special 2-leg corner is for use only with our CNSL0490 Quick Lid™ Extrusion. This special 2-leg design has channels that wrap the interior corners of the CNSL0490 Quick Lid™ Extrusion. Contact us if you have any questions about implementing this system and its components. See How It Works Below.
4 each required per Slam Lid.
Rivets Required For Installation: 2
ASSOCIATED COMPATIBLE PARTS:
- L0490 Quick Lid™ Extrusion
- L2470 Quick Lid™ Latch
- P2472 Quick Lid™ Hook Plate
Finish: Zinc Finish (unless another option is listed)
Material: 1.2mm/ 0.047" Steel
HOW IT WORKS
#1 - The front, back, or top panel of the case is an inset removable panel held in place by a custom extrusion, custom two-leg corners, specially designed hook plates, and a spring-loaded internal latch. Multiple latches may be used for larger panels.
#2 - Stick your finger into the access hole for the internal latch and push down on the internal spring-loaded latch mechanism to release the panel from the custom extrusion framework.
#3 - Pull the removable panel from the custom extrusion framework.
#4 - As you detach the removable panel, you can see the two hook plates with their offset flanges that grab the lip of the custom extrusion. Together with the internal spring-loaded latch(es) these hook plates act to firmly secure the panel to the extrusion framework. The latch can be installed with wood screws for a "clean" exterior look, or with rivets just as you would install any other part (and since this latch is internal, just make sure the rivet is installed so that the rivet head is on the EXTERIOR of the case!)
#5 - Here is a reverse view of the two hook plates and their offset flanges that grab the lip of the custom extrusion.
See Parts Pictures Above