E2228/2000 - 1/2" T-CHANNEL DIVIDER EXTRUSION( 6'6 lengths) )
- In Stock - Limited Aavailability
- 2.82 LBS
- 1.69 (in)
- 79.00 (in)
- 0.79 (in)
- Calculated at Checkout
T-Channel DividerExtrusion. Used to create partitions, divisions and compartments within cases.
NOTE: Mill finish unanodized extrusions can commonly incur surface abrasions during shipment from rubbing together if they incur harsh handling during the shipment process. This is not abnormal, and is easy to remedy by rubbing the extrusions with some #0000 Fine Grade Steel Wool, cheaply available at any hardware store.
NOTE: If you don't want to spend the cost of this extrusion, you can always use our E0775 Single Angle Extrusion to create partitions. Contact us for details, or watch our tutorial video on how to do this.
Rivets Required For Installation: Varies depending on length of section used, as well as associated parts that may be riveted through it.
Depending on your case design some rivets may require backing washers. Most rivets will install through the interior leg of the extrusion and therefore require no backing washers.
All Cases utilizing 3/8" wall panels.
- All Cases
ASSOCIATED COMPATIBLE PARTS:
- All Of Our Corner Braces.
- Mates with itself
Material: Mill Finished Aluminum
See Parts Pictures Above