H1053Z - SURFACE MOUNT SPRING HANDLE
- In Stock
- 0.50 LBS
- 5.50 (in)
- 3.00 (in)
- 0.50 (in)
- Calculated at Checkout
Standard heavy-duty surface handle. This is a one-piece spring-loaded assembly that mounts to the exterior case surface without requiring any cutout and allows for comfortable carrying of cases. The surface-mout alternative to our recessed CNSH1821 handle.
Rivets Required For Installation: 5
Utilize backing washers.
THIS ITEM REQUIRES NO CUTOUT IN THE CASE WALL TO INSTALL.
MINIMUM RECOMMENDED CASE DIMENSIONS:
Typically, cases 70 pounds or less.
- Small Utility Case
- Small Mixer Case
ASSOCIATED COMPATIBLE PARTS:
Material: 1.2mm / 0.047" Steel
See Product Pictures Above
Generous size, comfortable rubber grip. Lays flat but is easy to lift and use when required. Comes with a backer plate for use inside the case -- Just drill out the top center rivet holding the front, back and handle together (top center in photo). It's a little tricky to apply the front plate and handle with the spring in the right position, but doesn't require special tools or skills. I attached the top center rivet first, after drilling the hole through the case, then drillled the bottom center hole and installed that rivet. Then drill and rivet the 4 remaining holes.
I have purchased numerous items from DIY and when I had questions I called and got the answers I needed. Great experience will continue to shop and use.
Handles are great and works well and folds down when not in use.
This is a very strong spring loaded handle. The stay down when not in use and do not flap around. I had to reinforce the plywood side of the case so that I could carry it like a brief case on the long side. This is only due to the excessive weight and the length of the side. The handle has a hard rubber/plastic grip so it is comfortable to hold on to.
The handles are very durable. Have purchased several over the past year or two and they are well built products.