L0566N - DRAW LATCH - guitar case style
- In Stock
- 0.20 LBS
- 2.00 (in)
- 3.75 (in)
- 0.40 (in)
- Calculated at Checkout
This is a traditional standard draw latch. This is a two-piece surface-mount latch and is key-lockable and nickel plated.
Rivets Required For Installation: 5 OUR RIVETS DO NOT FIT THESE HOLES - SMALLER DIAMETER RIVETS MUST BE PURCHASED AT YOUR LOCAL HARDWARE STORE, or you can slightly drill out the holes to accommodate our rivets.
Rivets may require backing washers depending on your case design and method of installation. Any rivets inserting through aluminum extrusions will not require a backing washer.
THIS ITEM REQUIRES NO CUTOUTS IN THE CASE WALLS TO INSTALL THE SPLIT FIXTURE ASSEMBLY.
Draw Latch Recommended Uses:
- Small To Medium Cases
MINIMUM RECOMMENDED CASE DIMENSIONS:
NOTE: May be used as a primary or secondary latch on medium to large cases, including cases that have removable lids, hinged access doors, or other removable panels.
- Small Tool Case
- Makeup Case
Material: 1.2mm / 0.047" Steel With Bright Nickel Finish
See Product Pictures Above